Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 446 (FRONT SUSPENSION SYSTEM)
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Section 446 (Front Suspension System)
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Section 446 (Front Suspension System)
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Front Suspension Location Index
- Front Shock Absorber And Coil Spring Removal/Installation
- Front Shock Absorber Inspection
- Front Shock Absorber Disposal
- Front Upper Arm Removal/Installation
- Front Upper Arm Inspection
- Front Lower Arms Removal/Installation
- Notes
- Caliper and Mounting Support Removal Note
- Front Lower Arm Ball Joint Removal Note
- Upper Arm Ball Joint Removal Note
- Bushing (Rear Side) Removal Note
- Bushing (Front Side) Removal Note
- Bushing (Shock Absorber Lower Side Connecting Part) Removal Note
- Bushing (Shock Absorber Lower Side Connecting Part) Installation Note
- Bushing (Front Side) Installation Note
- Bushing (Rear Side) Installation Note
- Clip Installation Note
- Front Lower Arm Inspection
- Front Stabilizer Removal/Installation
- Stabilizer Control Link Inspection
- Front CROSSMEMBER Removal/Installation
- Transverse Member Removal/Installation
- Front Suspension Tower Bar Removal/Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.