Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 446 (FRONT SUSPENSION SYSTEM)STABILIZER CONTROL LINK INSPECTION
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Stabilizer Control Link Inspection
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Stabilizer Control Link Inspection
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the stabilizer control link from the vehicle.
- Inspect the stabilizer control link for bending or damage. If there is any malfunction, replace it.
- Rotate the ball joint stud 10 times , and then rock it side to side 10 times.
- Measure the ball-joint rotational torque using an Allen wrench and a torque wrench.
Stabilizer control link ball joint rotational torque
- 0.2-2.0 N.m {3-20 kgf.cm, 2-17 in.lbf}
- If not within the specification, replace the stabilizer control link.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.