Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 446 (FRONT SUSPENSION SYSTEM)FRONT STABILIZER REMOVAL/INSTALLATIONSTABILIZER BRACKET INSTALLATION NOTE

2008 Mazda 6 s Sport, 4D Hatchback, Standard

Stabilizer Bracket Installation Note

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Stabilizer Bracket Installation Note

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Apply rubber grease to the inner side of the stabilizer bushing.
Align the outer side of the stabilizer slide stopper with the stabilizer bushing.
Install the stabilizer bracket.

Fig 1: Installing The Stabilizer Bracket
Courtesy of MAZDA MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.