Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015K900 V6REPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESELECTRONIC STABILITY CONTROL DIAGNOSIS
2015 Kia K900 V6
Electronic Stability Control Diagnosis
2015 Kia K900 V6SECTION Electronic Stability Control Diagnosis
- DTC Index
- DTC C1101: Battery Voltage High
- DTC C1102: Battery Voltage Low
- DTC C1112: Sensor Source Voltage
- DTC C1200: Wheel Speed Sensor Front-LH Open/Short
- DTC C1201: Wheel Speed Sensor Front-LH Range/Performance/Intermittent
- DTC C1202: Wheel Speed Sensor Front-LH Invalid/No Signal
- DTC C1203: Wheel Speed Sensor Front-RH Open/Short
- DTC C1204: Wheel Speed Sensor Front-RH Range/Performance/
- DTC C1205: Wheel Speed Sensor Front-RH Invalid/No Signal
- DTC C1206: Wheel Speed Sensor Rear-LH Open/Short
- DTC C1207: Wheel Speed Sensor Rear-LH Range/Performance/
- DTC C1208: Wheel Speed Sensor Rear-LH Invalid/No Signal
- DTC C1209: Wheel Speed Sensor Rear-RH Open/Short
- DTC C1210: Wheel Speed Sensor Rear-RH Range/Performance/Intermittent
- DTC C1211: Wheel Speed Sensor Rear-RH Invalid/No Signal
- DTC C1235: Primary Pressure Sensor-Electrical
- DTC C1237: Primary Pressure Sensor-Signal
- DTC C1260: Steering Angle Sensor Circuit-Signal
- DTC C1261: Steering Angle Sensor Not Calibrated
- DTC C1282: Yaw Rate & G Sensor-Electrical
- DTC C1283: Yaw Rate & G Sensor-Signal
- DTC C1285: Longitudinal G Sensor Not Calibrated
- DTC C1358: AVH Not Available Due To EPB In Emergency Release
- DTC C1503: TCS/ESC (ESP) Switch Error
- DTC C1513: Brake Switch Circuit Error
- DTC C1604: ECU Hardware Error
- DTC C1605: CAN Hardware Error
- DTC C1611: CAN Time-Out EMS
- DTC C1612: CAN Time-Out TCM
- DTC C1613: CAN Signal Error ECM (Check ECM)
- DTC C1616: CAN Bus OFF
- DTC C1623: CAN Time-Out Steering Angle Sensor
- DTC C1628: CAN Time-Out Cluster
- DTC C1638: ACC Communication Error
- DTC C1647: CAN Hardware Error - Sensor Channel
- DTC C1648: CAN Signal Error ECM For SCC (Check ECM)
- DTC C1649: CAN Time-Out ECM For SCC (Check ECM)
- DTC C1650: CAN Signal Error SCC
- DTC C1651: CAN Time-Out EPB
- DTC C1652: CAN Signal Error EPB
- DTC C1656: CAN Signal Error Cluster
- DTC C2112: Valve Relay Error
- DTC C2130: Brake Lamp Relay Error
- DTC C2227: Excessive Temperature Of Brake Disc
- DTC C2228: CAN Signal Error TCM For SCC (Check TCM)
- DTC C2380: ABS/TCS/ESC (ESP) Valve Error
- DTC C2402: Motor Electrical
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.