Control Circuit Inspection

2015 Kia K900 V6SECTION Control Circuit Inspection

■ Open Check 

  1. IG "OFF".
  2. Disconnect Stop Signal Electronic Module and HECU connector.
  3. Measure resistance between Pin No. 2 (HAC/DBC signal) terminal of Stop Signal Electronic Module harness connector and Pin No. 8 (Standard type), 39 (Premium type) stop relay control terminal of HECU harness connector.

    Specification:  Approx. below 1Ω

  4. Is the measured value within specifications?

    YES 

    • Go to "Short Check" procedure below.

    NO 

    • Repair open in stop lamp relay control circuit between the Stop Signal Electronic Module and HECU and then, Go to "VERIFICATION OF VEHICLE REPAIR " procedure.

■ Short Check 

  1. IG "OFF".
  2. Disconnect Stop Signal Electronic Module and HECU connector.
  3. Measure resistance between Pin No. 2 (HAC/DBC signal) terminal of Stop Signal Electronic Module harness connector and chassis ground.

    Specification:  Infinite (∞ Ω)

  4. Is the measured value within specifications?

    YES 

    • Go to "Short Check" procedure below.

    NO 

    • Repair short in stop lamp relay control circuit between the Stop Signal Electronic Module and HECU and then, Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.