SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015K900 V6REPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESELECTRONIC STABILITY CONTROL DIAGNOSISDTC C2380: ABS/TCS/ESC (ESP) VALVE ERRORDTC INFORMATIONDTC DETECTING CONDITION
2015 Kia K900 V6

DTC Information: DTC Detecting Condition

2015 Kia K900 V6SECTION DTC Detecting Condition
Item Detecting Condition Possible cause
DTC Strategy
  • Internal Monitoring
  1. Faulty HECU
Enable Conditions
  • If the valve relay is switched ON and corresponding solenoid driver OFF and the voltage of solenoid < 3.5 ± 0.5V continuously for 56ms, the failure is detected
  • If the valve relay is switched ON and corresponding solenoid driver ON and the voltage of solenoid > 1.5 ± 0.5V continuously for 56ms, the failure is detected
Fail Safe
  • Inhibit the ESP(ESC) control and allow the ABS/EBD control
  • The ESP(ESC) warning lamp is activated
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.