Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGENESIS2021GV80 2.5T ADVANCED, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 13 (ENGINE CONTROL SYSTEM - 3.5L)
2021 Genesis GV80 2.5T Advanced, AWD
Section 13 (Engine Control System - 3.5L)
2021 Genesis GV80 2.5T Advanced, AWDSECTION Section 13 (Engine Control System - 3.5L)
WARNING: This page is about a different variant/trim than selected.
- Components & Components Location
- Description & Operation
- Engine Control Module (ECM)
- ETC (Electronic Throttle Control) System
- Boost Pressure Sensor (BPS)
- Manifold Absolute Pressure Sensor (MAPS)
- Intake Air Temperature Sensor (IATS)
- Ejector Pressure Sensor (EPS)
- Engine Coolant Temperature Sensor (ECTS)
- Crankshaft Position Sensor (CKPS)
- Camshaft Position Sensor (CMPS)
- Knock Sensor (KS)
- Heated Oxygen Sensor (HO2S)
- Rail Pressure Sensor (RPS)
- Oil Pressure & Oil Temperature Sensor (OPTS)
- Accelerator Position Sensor (APS)
- Fuel Tank Pressure Sensor (FTPS)
- Injector
- Purge Control Solenoid Valve (PCSV)
- Variable Force Solenoid (VFS)
- Electric Waste Gate Actuator (EWGA)
- Fuel Pressure Control Valve (FPCV)
- Canister Close Valve (CCV)
- RCV Control Solenoid Valve
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.