Repair Procedures: Inspection

2021 Genesis GV80 2.5T Advanced, AWDSECTION Inspection
WARNING: This page is about a different variant/trim than selected.
  1. Connect the diagnostic tool on the Data Link Connector (DLC).
  2. Turn the ignition switch ON.
  3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
    Accelerator Position Output Voltage (V) [Supply Voltage = 5V]
    APS1 APS2
    C.T 0.7 ~ 0.8 0.325 ~ 0.425
    W.O.T 3.98 ~ 4.22 1.93 ~ 2.17
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.