Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 362 (CRUISE CONTROL - VEHICLES WITH: ADAPTIVE CRUISE CONTROL)
2021 Ford Edge SE, 4WD
Section 362 (Cruise Control - Vehicles With: Adaptive Cruise Control)
2021 Ford Edge SE, 4WDSECTION Section 362 (Cruise Control - Vehicles With: Adaptive Cruise Control)
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Diagnosis And Testing
- Cruise Control
- DTC Charts
- Symptom Chart(s)
- Pinpoint Tests
- Pinpoint Test A : The Adaptive Cruise Control Is Inoperative
- Pinpoint Test B : P0504, P0572, P0573 Or P1703
- Pinpoint Test C : B142E:78 Or B1433:54
- Pinpoint Test D : C1A67:08
- Pinpoint Test E : C1A67:96
- Pinpoint Test F : C1A67:97
- Pinpoint Test G : U0265:00
- Pinpoint Test H : U0100:00
- Pinpoint Test I : U0121:00
- Pinpoint Test J : U0140:00
- Pinpoint Test K : U0151:00
- Pinpoint Test L : U0155:00
- Pinpoint Test M : U0158:00
- Pinpoint Test N : U0212:00
- Pinpoint Test O : U0265:00
- Pinpoint Test P : U0423:82
- Pinpoint Test Q : U3003:16
- Pinpoint Test R : U3003:17
- Cruise Control
- General Procedures
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.