Pinpoint Test F : C1A67:97: Notes

2021 Ford Edge SE, 4WDSECTION Notes
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Cruise Control for schematic and connector information.

Normal Operation and Fault Conditions 

REFER to: Cruise Control - System Operation and Component Description .

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
C1A67:97 Forward Looking Sensor: Component Or System Operation Obstructed Or Blocked Set by the CCM as a continuous memory and on-demand DTC if the CCM detects an obstruction or if the sensor is blocked. This DTC may also set when the CCM does not see a vehicle or object on the road for an extended period.
NOTE: If a snow plow or similar equipment is installed on the front end of the vehicle, this may obstruct the CCM radar sensor, causing the ACC to operate erratically. The ACC should be disabled using the menu options when a snow plow or similar equipment is installed.

Possible Sources 

  • Front bumper
  • Blockage or obstruction
  • CCM mounting bracket
  • CCM alignment
  • CCM
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.