Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE
Section 105 (Supplemental Inflatable Restraint System)
WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Description & Operation
- Component Locations
- System Operation Check
- Air Bag Safety Precautions
- Adjustments
- Disabling & Activating Air Bag System
- Disposal Procedures
- Post-Collision Inspection
- Removal & Installation
- Diagnostics
- Diagnostic Tests
- Test A: Air Bag Warning Light On Continuously-RCM Disconnected Or Inoperative
- Test B: RCM Bracket Ground Resistance High (DTC B1921)
- Test C: Incorrect Vehicle Identification Code (DTC C1414)
- Test D: Driver-Side Air Bag Circuit Short To Ground (DTC B1887)
- Test E: Driver-Side Air Bag Circuit Short To Battery Or Ignition (DTC B1916)
- Test F: Passenger-Side Air Bag Circuit Short To Ground (DTC B1888)
- Test G: Passenger-Side Air Bag Circuit Short To Battery Or Ignition (DTC B1925)
- Test H: Driver-Side Air Bag Resistance High (DTC B1932)
- Test I: Passenger-Side Air Bag Resistance High (DTC B1933)
- Test J: Driver-Side Air Bag Low Resistance (DTC B1934)
- Test K: Passenger-Side Air Bag Resistance Low (DTC B1935)
- Test L: Passenger Air Bag Deactivation (Pad) Switch Fault (DTC B1871)
- Test M: Passenger Air Bag Deactivation (Pad) Switch Warning Light Inoperative (DTC B1884)
- Test N: Passenger Air Bag Deactivation (Pad) Switch Warning Light Short To Battery (DTC B1890)
- Test O: Air Bag Tone Warning Indicator Circuit Short To Ground Or Open (DTC B1892)
- Test P: Air Bag Tone Warning Indicator Circuit Short To Battery Or Ignition (B1891)
- Test Q: Air Bag Warning Light Circuit Open (DTC B1869)
- Test R: Air Bag Warning Light Short To Battery Voltage (DTC B1870)
- Test S: Left PRETENSIONER Circuit Resistance Low Or High (DTC B1885/B1877)
- Test T: Right PRETENSIONER Circuit Resistance Low Or High (DTC B1881/B1886)
- Test U: Left PRETENSIONER Circuit Short To Battery Or Ignition (DTC B1878)
- Test V: Left PRETENSIONER Circuit Short To Ground (DTC B1879)
- Test W: Right PRETENSIONER Circuit Short To Battery Or Ignition (DTC B1882)
- Test X: Right PRETENSIONER Circuit Short To Ground (DTC B1883)
- Test Y: No Communication With RCM
- Wire Repair
- Torque Specifications
- Wiring Diagrams
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
