2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Restraints Control Module (RCM)

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

RCM contains microcomputer, which monitors electrical system components and connections. RCM performs a system self-check of air bag system internal circuits every time ignition switch is turned to RUN position. RCM also energizes AIR BAG warning light during initial system self-check and whenever a fault is detected. Faults are stored in RCM memory and translated into flash codes, which are displayed through AIR BAG warning light. RCM also communicates through Data Link Connector (DLC) current and historical Diagnostic Trouble Codes (DTCs).

If a system fault exists and AIR BAG warning light is malfunctioning, RCM signals Generic Electronic Module (GEM) to activate a chime, indicating need for service.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.