2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Retrieving Fault Codes

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Connect scan tool to Data Link Connector (DLC), located under instrument panel near steering column. Turn ignition switch to RUN position. Follow manufacturer's instructions for scan tool being used. All continuous DTCs will be displayed on scan tool screen. Record DTCs for reference. See DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATIONΒ  table. When DTCs are cleared, they cannot be retrieved.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.