2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Using Scan Tool

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. To retrieve continuous Diagnostic Trouble Codes (DTCs) and run self-test diagnostics, connect scan tool to Data Link Connector (DLC) following manufacturer's instructions. DLC is located under instrument panel, near steering column.
  2. If self-test passes and no DTCs are retrieved, go to diagnostic symptoms table to continue diagnosis. See DIAGNOSTIC SYMPTOMS  table. If DTCs are retrieved, go to diagnostic trouble code identification table to continue diagnosis. See DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION  table. If restraints control module cannot be accessed by scan tool, go to TEST Y: NO COMMUNICATION WITH RCM  under DIAGNOSTIC TESTS  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.