Rear End Spoiler Replacement

2019 Chevrolet Trax Premier, AWDSECTION Rear End Spoiler Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM4526756
Callout Component Name

Preliminary Procedures

  1. Liftgate Upper Side Trim Finish Panel Replacement
  2. Liftgate Side Applique Replacement (Chevrolet) Liftgate Side Applique Replacement (Buick) 
1 Rear End Spoiler Bolt [4x]
CAUTION:

Refer to Fastener Caution .


Tighten 
5 N.m (44 lb in)
2 Rear End Spoiler Nut [3x]
Tighten 
5 N.m (44 lb in)
3 Rear End Spoiler Retainer[2x]
Procedure 
Using the appropriate tool, release the 2 rear end spoiler retainers.
4 Rear End Spoiler

Procedure

  1. Disconnect the electrical connector.
  2. Disconnect the rear window washer hose from the rear window washer nozzle.
  3. Transfer components as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.