SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 54 (EXTERIOR TRIM)REPAIR INSTRUCTIONSLIFTGATE SIDE APPLIQUE REPLACEMENT (BUICK)
2019 Chevrolet Trax Premier, AWD

Liftgate Side Applique Replacement (Buick)

2019 Chevrolet Trax Premier, AWDSECTION Liftgate Side Applique Replacement (Buick)
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM3429064
Callout Component Name
1 Liftgate Side Applique

Procedure

  1. The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
  2. Apply a suitable tape around the liftgate side applique.
  3. Use a heat gun or equivalent to loosen the tape on the lower section of the liftgate side applique. Use a plastic flat bladed tool to assist in removal.
  4. Using a suitable trim-type release tool start from the top edge and release the 2 retainers.
  5. Clean any remaining residue with a 50/50 mixture by volume of isopropyl alcohol and clean drinkable water. Wipe surface dry with a clean lint-free towel.
  6. When removing protective liner from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
  7. Using the palm of the hand, apply even pressure to the liftgate side applique to ensure the retainers are seated and full adhesion is made.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.