Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2018A5 QUATTRO PRESTIGE, 2D CONVERTIBLEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 157 (CONTROLS, HOUSING (0GC))
2018 Audi A5 Quattro Prestige, 2D Convertible
Section 157 (Controls, Housing (0GC))
2018 Audi A5 Quattro Prestige, 2D ConvertibleSECTION Section 157 (Controls, Housing (0GC))
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2020 Audi S3, 2020 Audi A3 Quattro, 2020 Audi A3, 2019 Audi S3, and 2019 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- 34 Controls, Housing
- MECHATRONIC
- Selector Mechanism
- Overview - Selector Lever Handle
- Overview - Selector Mechanism
- Emergency Release From P
- Selector Lever Handle, Removing And Installing
- Button In Handle, Moving Into Installation Position
- Selector Mechanism, Removing And Installing
- Selector Mechanism, Checking
- Selector Lever Cable, Checking And Adjusting
- Parking Lock Shaft Seal, Replacing
- Transmission, Removing And Installing
- Bevel Box
- SUBFRAME Mount
- Transmission, Transporting
- Securing On Engine And Transmission Holder
- Transmission Fluid Circuit
- Transmission Fluid
- Special Tools
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.