Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Selector Lever Handle, Removing And Installing: Removing
-- Pull the parking brake button to activate the electro-mechanical parking brake.
-- Move the selector lever into "D/S" position.
-- Switch the ignition off.
-- Carefully pry out the selector lever boot with the : T10383/1 on both sides -arrows- and then fold it upward.
-- Turn the locking ring all the way in the direction of -arrow A-.
- The tab -1- on the locking ring is offset to the tab -2- on the selector lever handle.
-- Remove the selector lever handle -1- upward with the selector lever boot in direction of -arrow A- without touching the locking button -2-.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.