Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 61 (ON BOARD DIAGNOSTIC (OBD) - A/T 01L)
1996 Audi A4 Base, Standard
Section 61 (On Board Diagnostic (OBD) - A/T 01L)
1996 Audi A4 Base, StandardSECTION Section 61 (On Board Diagnostic (OBD) - A/T 01L)
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi RS 6. However, it is still accessible from the selected car via links, so may be relevant.
- On Board Diagnostic (OBD)
- Notes
- Malfunction recognition by the Transmission Control Module (TCM)
- Transmission Control Module (TCM), backup functions
- Malfunction Indicator Lamp (MIL), function
- Conditions for recognizing a driving cycle (dcy)
- On Board Diagnostic (OBD), technical data
- On Board Diagnostic (OBD), function
- For additional information see:
- Safety precautions
- On Board Diagnostic (OBD), initiating program
- Electrical/electronic components, locations
- Notes
- Location of Automatic Transmission Control Module (TCM) -J217-
- Automatic Transmission Control Module (TCM) -J217-, disconnecting multi-pin connector
- Engine Control Module (ECM)
- Data Link Connector (DLC)
- Transmission internal wiring harness, integrated Transmission Fluid Temperature Sensor -G93-
- ABS Control Module -J104-
- OBD of ABS Control Module -J104-
- Multi-function Transmission Range (TR) switch -F125-
- Valve body
- Sensor for Transmission RPM -G182-
- Sender for Transmission Output RPM -G195-
- Speedometer Vehicle Speed Sensor (VSS) -G22-
- Shift Lock solenoid -N110-
- Tiptronic Transmission Range (TR) Switch -F189-
- Starting Interlock Relay-J207-
- Transmission Range (TR)Selector Lever Display -Y6-
- Brake Light Switch -F-
- Cruise Control Switch -E45-
- On Board Diagnostic (OBD), available functions using VAG 1551 Scan Tool (ST)
- Check DTC Memory (scan tool function 02)
- Diagnostic Trouble Code (DTC) tables
- Diagnostic Trouble Code (DTC) table; Part 1, up to display group number 17968 / P1560
- Diagnostic Trouble Code (DTC) table; Part 2, up to display group number 18267 / P1861
- Output Diagnostic Test Mode (DTM) (scan tool function 03)
- Erase DTC memory (scan tool function 05)
- Code Control Module (Scan tool function 07)
- Read Measuring Value Block (scan tool function 08)
- Notes
- Work procedure
- Available display group numbers
- Read Measuring Value Block display group table
- Read Measuring Value Block Display Group 001
- Read Measuring Value Block Display Group 002
- Read Measuring Value Block Display Group 003
- Read Measuring Value Block Display Group 004
- Read Measuring Value Block Display Group 005
- Read Measuring Value Block Display Group 006
- Read Measuring Value Block Display Group 007
- Read Measuring Value Block Display Group 008
- Read Measuring Value Block Display Group 009
- Read Measuring Value Block Display Group 010
- Read Measuring Value Block Display Group 011
- Read Measuring Value Block Display Group 012
- Read Measuring Value Block Display Group 013
- Read Measuring Value Block Display Group 125
- CAN-Bus, function
- Electrical testing
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.