Code Control Module (Scan tool function 07)

The transmission Control Module (TCM) can be coded.

• -Connect Diagnosis and Information System VAS 5051 or VAG 1551 Scan Tool (ST) and select" Transmission Electronics" with address word 02. See ON BOARD DIAGNOSTIC (OBD) . Ignition must be switched on.

Indicated on display:

Fig 1: VAG 1551 Scan Tool Display (Rapid Data Transfer)

Courtesy of AUDI OF AMERICA, INC.

• Press buttons 0 and 7. (With 07, function "Control module, coding" is selected)

Indicated on display:

Fig 2: VAG 1551 Scan Tool Display (07 Control Module Coding)

Courtesy of AUDI OF AMERICA, INC.

• Confirm input by pressing Q button.

Indicated on display:

Fig 3: VAG 1551 Scan Tool Display (Enter Code Number XXXXX)

Courtesy of AUDI OF AMERICA, INC.

• Entering code. See Fig 4.

Code table 

Fig 4: TCM Code Table

Courtesy of AUDI OF AMERICA, INC.

¹⁾ RdW: Applies to all oter countries

²⁾ DSP: Dynamic Shift program

• Confirm input by pressing Q buttom.

• Press --> button.

Indicated on display:

Fig 5: VAG 1551 Scan Tool Display (Selection Function XX)

Courtesy of AUDI OF AMERICA, INC.

• Check control module version (press buttons 0 and 1 ), confirm input by pressing Q button and check code. See ON BOARD DIAGNOSTIC (OBD) .

Indicated on Display Attempt was made to enter a code that was not valid or not recognized by the control module.

Fig 6: VAG 1551 Scan Tool Display (Coding XXXXX Not Accepted)

Courtesy of AUDI OF AMERICA, INC.