Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2002GOLF GLS, 2.0 K, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 91 (2.8L & 3.2L - GENERIC SCAN TOOL, ENGINE CODE(S): AFP, BDF, BJS [A4 PLATFORM] (28 IGNITION/GLOW PLUG SYSTEM - ST GENERIC SCAN TOOL))ST GENERIC SCAN TOOLDIAGNOSTIC MODE, SELECTINGDIAGNOSTIC MODE 9: VEHICLE INFORMATIONNOTES
2002 Volkswagen Golf GLS, 2.0 K, Standard
Diagnostic mode 9: Vehicle information: Notes
2002 Volkswagen Golf GLS, 2.0 K, StandardSECTION Notes
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen R32, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Function
In this diagnostic mode, vehicle specific diagnostic data such as e.g. the control module versions will be displayed.
Requirement
- There must not be any DTCs stored in DTC memory. Refer to Diagnostic mode 3: Check DTC Memory
Work procedure
- Connect diagnostic tester. Refer to Diagnostic tester, connecting
- Switch ignition on.
- Under address word 33, select "Diagnostic mode 9: Vehicle information".
- Select desired vehicle information "Test-ID XX".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.