SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 928 (CRUISE CONTROL SYSTEM)CLUTCH SWITCH ASSYREPLACEMENT
2004 Toyota Matrix XR, FWD, Standard

Clutch Switch ASSY: Replacement

2004 Toyota Matrix XR, FWD, StandardSECTION Replacement
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Installation is in the reverse order of removal.

  1. REMOVE FRONT DOOR SCUFF PLATE LH (SEE  REPLACEMENT  ) 
  2. REMOVE COWL SIDE TRIM SUB-ASSY LH (SEE  REPLACEMENT  ) 
  3. REMOVE INSTRUMENT PANEL FINISH LOWER PANEL LH (SEE  REPLACEMENT  ) 
  4. REMOVE CLUTCH SWITCH ASSY 
    1. Disconnect the connector.
    2. Loosen the nut and remove the clutch switch assy.
      Fig 1: Removing Clutch Switch Assy
      G03553623Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL CLUTCH SWITCH ASSY 
    1. Insert the clutch switch assy by turning it until the bolt touches the cushion of the clutch pedal.
    2. Adjust the clutch switch assy to the specified value between the cushion and the bracket as shown in Fig 2 .
    3. Tighten the lock nut to fix the clutch switch assy.
      Fig 2: Installing Clutch Switch Assy
      G03553624Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.