Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 360 (ABS - DIAGNOSTICS)
2004 Toyota Matrix XR, FWD, Standard
Section 360 (Abs - Diagnostics)
2004 Toyota Matrix XR, FWD, StandardSECTION Section 360 (Abs - Diagnostics)
WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- How To Proceed With Troubleshooting
- Customer Problem Analysis Check
- Pre-Check
- Diagnostic Trouble Code Chart
- Parts Location
- Terminals Of Ecu
- Problem Symptoms Table
- Diagnostic Tests
- DTC C0200/31, C0205/32, C0210/33, C0215/34: Speed Sensor Circuit
- DTC C0226/21: Abs & VSC Solenoid Circuit
- DTC C0278/11: Abs & VSC Relay Circuit
- DTC C1203/53: ECM Communication Circuit Malfunction
- DTC C1223/43: Abs Control System Malfunction
- DTC C1231/31: Steering Angle Sensor Circuit
- DTC C1232/32: Deceleration Sensor Circuit
- DTC C1234/34: Yaw Rate Sensor Circuit
- DTC C1241/41: IG Power Source Circuit
- DTC C1249/49: Stop Light Switch Circuit
- DTC C1251/51: Abs & VSC Pump Motor Lock
- DTC C1310/11: Active Brake Booster Solenoid Circuit
- DTC C1311/12: Brake Inhibit Relay Circuit
- DTC C1337/37: Some Tire Is Different Size From The Other Tires
- DTC C1340/48: Center Differential Lock Circuit
- DTC C1360/61: Master Cylinder Pressure Sensor Circuit
- DTC C1361/62: Abnormally Battery Voltage Of VSC Sensor
- DTC C1362/36: Malfunction In Sensor Set Value (VSC Sensor System)
- DTC C1363/63: Booster Pedal Force Switch Circuit
- DTC 42: Ecu Communication System Malfunction
- DTC 44: NEO Signal Circuit
- DTC 53: ECM Communication Circuit Malfunction
- Diagnostic Trouble Codes Normal Code - Malfunction In ECM
- Diagnostic Trouble Codes Non Code - Translate Ecu Malfunction
- Diagnostic Trouble Codes Abs Warning Light Always On - Malfunction In Skid Control Ecu
- System Tests
- Wiring Diagrams
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.