Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 30 (ENGINE MECHANICAL)REPAIR INSTRUCTIONSENGINE MOUNT REPLACEMENT - RIGHT SIDEREMOVAL PROCEDURE

2013 Suzuki SX4 Crossover, Automatic CVT Trans

Removal Procedure

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Removal Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Right Upper Front Engine Mount Bracket Bolt

Courtesy of SUZUKI OF AMERICA CORP.

Remove the air cleaner assembly. Refer to REMOVAL PROCEDURE .
Remove the drive belt. Refer to REMOVAL PROCEDURE .
Support the engine. Refer to ENGINE SUPPORT FIXTURE .
Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
Remove three upper engine mount bracket bolts (1).
Loosen right upper front engine mount bracket bolt (2).

Fig 2: Removing Mount & Lower Bracket
Courtesy of SUZUKI OF AMERICA CORP.
Remove the upper engine mount bracket nuts (1).
Remove the lower bracket bolts (2).
Remove the ABS connector clip from the frame.
Remove the mount (3) and the lower bracket (4) from the vehicle.

Fig 3: Removing Engine Mount From Lower Bracket
Courtesy of SUZUKI OF AMERICA CORP.
Remove the upper bracket bolt (1) from the bracket.
Remove the upper bracket.
Remove the engine mount (3) from the lower bracket (4).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.