Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2022IMPREZA BASE, 4D SEDAN, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISSTEERINGELECTRONIC STEERINGPOWER STEERING SYSTEM (DIAGNOSTICS)
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT Trans
Power Steering System (Diagnostics)
2022 Subaru Impreza Base, 4D Sedan, Automatic CVT TransSECTION Power Steering System (Diagnostics)
- Basic Diagnostic Procedure
- Check List For Interview
- General Description
- Electrical Component Location
- Control Module I/O Signal
- Inspection Mode
- Warning Light Illumination Pattern
- Diagnostic Procedure For Subaru Select Monitor Communication
- Data Monitor
- Freeze Frame Data
- Diagnostic Trouble Code (DTC)
- Diagnostic Procedure With Diagnostic Trouble Code (DTC)
- DTC C2511: Torque Sensor Main
- DTC C2512: Torque Sensor Sub
- DTC C2513: Torque Sensor Much Tolerance
- DTC C2514: Torque Sensor Power Supply
- DTC C2521: Motor Malfunction
- DTC C2522: Resolver Sensor
- DTC C2531: Control Module CPU
- DTC C2532: Control Module Peripheral Circuit
- DTC C2533: Control Module Board Temperature Sensor
- DTC C2541: Vehicle Dynamics Control Module Vehicle Speed Sensor
- DTC C2543: Error Passive
- DTC C2544: Auto Start Stop System
- DTC C2545: Eyesight System
- DTC C2546: Eyesight Value
- DTC C2547: Eyesight Check Sum
- DTC C2551: Power Supply Relay
- DTC U0073: Control Module Communication Bus Off
- DTC U0100: Lost Communication With ECM/Pcm "A"
- DTC U0122: Lost Communication With Vehicle Dynamics Control Module
- DTC U0126: Lost Communication With Steering Angle Sensor Module
- DTC U0155: Lost Communication With Instrument Panel Cluster (IPC) Control Module
- DTC U0293: Lost Communication With Hybrid Powertrain Control Module
- DTC U0401: Invalid Data Received From ECM/Pcm "A"
- DTC U0416: Invalid Data Received From Vehicle Dynamics Control Module
- DTC U1120: Lost Communication With AUTOSTART Stop Control Module
- DTC U1235: Lost Communication With Eyesight
- DTC U1433: Invalid Data Received From Eyesight
- DTC U1469: Invalid Data Received From AUTOSTART Stop Control Module
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.