Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Engine Controls (Diagnostics) (2.0L) - Introduction
- Basic Diagnostic Procedure
- Check List for Interview
- General Description
- Electrical Component Location
- Engine Control Module (ECM) I/O Signal
- Engine Condition Data
- Data Link Connector
- General Scan Tool
- Operation
- How To Use General Scan Tool
- Mode $01 (Current Powertrain Diagnostic Data)
- Mode $02 (Powertrain Freeze Frame Data)
- Mode $03 (Emission-Related Powertrain DTC)
- Mode $04 (Clear/Reset Emission-Related Diagnostic Information)
- Mode $06
- Mode $07
- Mode $08 (Request Control For On-Board System, Test, And Component)
- Mode $09
- Operation
- Subaru Select Monitor
- Read Diagnostic Trouble Code (DTC)
- Inspection Mode
- Drive Cycle
- Clear Memory Mode
- Active Test
- Malfunction Indicator Light
- Diagnostics for Engine Starting Failure
- List of Diagnostic Trouble Code (DTC)
- Diagnostic Procedure without Diagnostic Trouble Code (DTC)
- Check Si-Drive (SUBARU Intelligent Drive) System
- Diagnosis
- Si-Drive Mode Indication Does Not Change And Modes Do Not Switch After Switching Si-Drive Modes
- When The Si-Drive Mode Is Changed, "S", "I" Or "S#" Flashes In Combination Meter Si-Drive Mode Display In Approx. 5 Seconds
- When The Si-Drive Mode Is Changed, "S", "I" Or "S#" Flashes In Combination Meter Si-Drive Mode Display
- Check Si-Drive (SUBARU Intelligent Drive) System
- General Diagnostic Table
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.