Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISBRAKESPARKING BRAKE SYSTEMPARKING BRAKE SYSTEM (DIAGNOSTICS)
2014 Subaru Legacy 2.5i, Automatic CVT Trans
Parking Brake System (Diagnostics)
2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION Parking Brake System (Diagnostics)
- Basic Diagnostic Procedure
- Check List for Interview
- General Description
- Electrical Component Location
- Control Module I/O Signal
- Subaru Select Monitor
- Read Diagnostic Trouble Code (DTC)
- Inspection Mode
- Clear Memory Mode
- Warning Light Illumination Pattern
- Inspection
- Brake Warning Light, Electronic Parking Brake Warning Light And Hill Hold Indicator Light Do Not Come On
- Hill Hold Indicator Light Do Not Go Off
- Electronic Parking Brake Warning Light And Hill Hold Indicator Light Do Not Go Off
- Brake Warning Light Does Not Go Off
- Brake Warning Light Remains Blinking
- List of Diagnostic Trouble Code (DTC)
- Diagnostic Procedure with Diagnostic Trouble Code (DTC)
- DTC C0221 Parking Position Switch
- DTC C0222 Hill Hold Switch Circuit
- DTC C0231 ECM Failure
- DTC C0232 At Abnormal
- DTC C0233 Mt Shift Switch Circuit
- DTC C0234 VDC Failure
- DTC C0235 Ignition Switch Circuit
- DTC C0236 Cruise Controller Communication Error
- DTC C0241 Electrical Control Module
- DTC C0242 Power Supply Voltage Failure
- DTC C0242 Internal Power Supply Voltage Abnormal
- DTC C0243 Parameter Selection Error
- DTC C0251 Actuator Line (Abnormal)
- DTC C0252 Motor Malfunction
- DTC C0253 Actuator Stroke Excess
- DTC C0261 Improper Can Communication
- DTC C0262 TCM Communication Circuit
- Diagnostic Procedure
- DTC C0263 ECM Communication Circuit
- DTC C0264 VDC Communication System
- DTC C0265 Body Integrated Module Communication Circuit
- DTC C0266 Cruise Controller Communication System
- DTC C0267 Meter Communication System
- DTC C0271 Force Sensor Line (Abnormal)
- DTC C0272 Temperature Sensor Line (Abnormal)
- DTC C0273 Stroke Sensor Line (Abnormal)
- DTC C0274 Clutch Sensor Circuit
- DTC C0275 Longitudinal G Sensor Circuit
- DTC C0281 Mid Stop Condition
- DTC C0282 Emergency Cancel Status
- General Diagnostic Table
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.