Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
2010 Saab 9-5
Steering Column Assembly
2010 Saab 9-5SECTION Steering Column Assembly
- Technical data
- Technical description
- Fault diagnosis, fault codes
- Steering Column Assembly DTC Index
- DTC B1023: Internal Switch Fault
- DTC B144C: Inverted RUN/CRANK Relay Circuit
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Component Testing
- Repair Instructions
- DTC B2515: Steering Column Lock Motor, Feedback Circuit Not Reasonable
- DTC B2897: Steering Column Lock Motor, Locking Circuit
- DTC B305A: Steering Column Lock, No Communication
- DTC B2910: Steering Column Lock, Incorrect Code
- Fault diagnosis, symptoms
- Adjustment Replacement
- Time studies - Steering column assembly
- Intermediate Steering Shaft Replacement
- Steering Column Trim Cover Replacement
- Steering Column Lock Control Module Replacement
- Turn Signal Switch Bracket Replacement
- Turn Signal Multifunction Switch Replacement
- Steering Wheel Replacement
- Steering Column Replacement
- Steering Column Lock Control Module Programming and Setup
- Component location
- Wiring diagram
- Bulletin
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.