Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Headlamp Levelling Actuator Replacement (Halogen): Removal
2010 Saab 9-5SECTION Removal
- Remove the front bumper fascia. Refer to FRONT BUMPER FASCIA REPLACEMENT .
- Remove the headlamp. Refer to HEADLAMP REPLACEMENT .
- Remove the headlamp bulb low beam. Refer to HEADLAMP BULB REPLACEMENT (XENON - LEFT SIDE) , HEADLAMP BULB REPLACEMENT (XENON - RIGHT SIDE) , HEADLAMP BULB REPLACEMENT (HIGH BEAM) or HEADLAMP BULB REPLACEMENT (LOW BEAM) .
- Remove the headlamp bulb dust covers.
- Rotate the adjuster (horizontal/vertical) with a 6 mm Allen key (5) clockwise to the block.
- Rotate the headlamp levelling actuator with a screwdriver (6) clockwise at 60° (headlamp left side; headlamp right side anticlockwise).
- Move the headlamp levelling actuator in upper direction, until the headlamp range adjuster is detached from the reflector.
- Remove the headlamp levelling actuator through the dipped beam opening (8) and disconnect the electrical connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.