Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Bumper Fascia Replacement
2010 Saab 9-5SECTION Front Bumper Fascia Replacement
| Callout | Component Name |
|---|---|
Preliminary Procedure
NOTE:
Cover the head lamps to avoid scratches.
|
|
| 1 | Front Bumper Fascia Fastener (Qty: 6) |
| 2 | Front Bumper Fascia Fastener (Qty: 6) |
| 3 | Front Bumper Fascia Plastic Retainer (Qty: 4) |
| 4 | Front Bumper Fascia Fastener (Qty: 2) Refer to FASTENER CAUTION . Procedure Loosen the fastener to release the fascia. Tighten 25 Nm (18 lb ft) |
| 5 | Front Bumper Fascia Procedure
NOTE:
Be careful in the headlight area. The headlight molding comes off with the fascia.
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.