Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 741 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)
2006 Pontiac G6 GTP, 2D Coupe, Standard
Section 741 (Battery, Charging System And Starting System)
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Section 741 (Battery, Charging System And Starting System)
WARNING: This page is about a different car, the 2007 Saturn Sky. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Code Index
- Diagnostic Starting Point - Engine Electrical
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- DTC B1325
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Procedures
- DTC C0899
- DTC C0900
- DTC P0560
- DTC P0562
- DTC P0563
- DTC P0615
- DTC P0616
- DTC P0617
- DTC P0621
- DTC P0622
- DTC P0626
- DTC P2500
- DTC P2501
- Symptoms - Engine Electrical
- Battery Inspection/Test
- Battery Charging
- Battery Electrical Drain/Parasitic Load Test
- Battery Common Causes of Failure
- Jump Starting in Case of Emergency
- Charging System Test
- Charge Indicator Always On
- Charge Indicator Inoperative
- Generator Noise Diagnosis
- Starter Solenoid Does Not Click
- Starter Solenoid Clicks, Engine Does Not Crank
- Engine Cranks Slowly
- Starter Motor Noise Diagnosis
- Repair Instructions
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.