Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015JUKE SL, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM (NISMO RS - INTRODUCTION))
2015 Nissan-Datsun Juke SL, 4WD
Section 1 (Engine Control System (NISMO RS - Introduction))
2015 Nissan-Datsun Juke SL, 4WDSECTION Section 1 (Engine Control System (NISMO RS - Introduction))
WARNING: This page is about a different variant/trim than selected.
- Precaution
- Preparation
- System Description
- Component Parts
- Engine Control System
- ECM
- Accelerator Pedal Position Sensor
- Electric Throttle Control Actuator
- Ignition Coil With Power Transistor
- Fuel Injector
- High Pressure Fuel Pump
- Fuel Rail Pressure Sensor
- Low Pressure Fuel Pump
- Fuel Tank Temperature Sensor
- Fuel Level Sensor
- Mass Air Flow Sensor (With Intake Air Temperature Sensor 1)
- Turbocharger
- Turbocharger Boost Sensor (With Intake Air Temperature Sensor 2)
- Engine Coolant Temperature Sensor
- Crankshaft Position Sensor (Pos)
- Camshaft Position Sensor (Phase)
- Intake Valve Timing Control Solenoid Valve
- Exhaust Valve Timing Control Position Sensor
- Exhaust Valve Timing Control Solenoid Valve
- Air Fuel Ratio (A/F) Sensor 1
- Heated Oxygen Sensor 2
- Knock Sensor
- Engine Oil Pressure Sensor
- Engine Oil Temperature Sensor
- Cooling Fan
- EVAP Canister Purge Volume Control Solenoid Valve
- EVAP Canister Vent Control Valve
- EVAP Control System Pressure Sensor
- Battery Current Sensor (With Battery Temperature Sensor)
- Malfunction Indicator Lamp (Mil)
- Oil Pressure Warning Lamp
- Refrigerant Pressure Sensor
- Stop Lamp Switch & Brake Pedal Position Switch
- Clutch Pedal Position Switch
- ASCD Steering Switch
- Information Display
- Structure And Operation
- System
- Engine Control System
- Direct Injection Gasoline System
- Fuel Pressure Control
- Electric Ignition System
- Intake Valve Timing Control
- Exhaust Valve Timing Control
- Turbocharger Boost Control
- Engine Protection Control At Low Engine Oil Pressure
- Fuel Filler Cap Warning System
- Air Conditioning Cut Control
- Cooling Fan Control
- Starter Motor Drive Control
- Evaporative Emission System
- Automatic Speed Control Device (ASCD)
- Integrated Control System
- Can Communication
- Operation
- On Board Diagnostic (OBD) System
- Diagnosis System (ECM)
- Diagnosis Description
- 1ST Trip Detection Logic And Two Trip Detection Logic
- DTC And Freeze Frame Data
- Counter System
- Explanation For Driving Patterns For "Misfire <Exhaust Quality Deterioration>", "Fuel Injection System"
- Explanation For Driving Patterns Except For "Misfire <Exhaust Quality Deterioration>", "Fuel Injection System"
- Driving Patterns
- System Readiness Test (SRT) Code
- Permanent Diagnostic Trouble Code (Permanent DTC)
- Malfunction Indicator Lamp (Mil)
- On Board Diagnosis Function
- Consult Function
- Diagnosis Description
- Component Parts
- Ecu Diagnosis Information
- Wiring Diagram
- Basic Inspection
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.