Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015JUKE SL, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (EXCEPT NISMO RS ECU DIAGNOSIS & DTC TESTS U0101-P0137)BASIC INSPECTIONSERVICE AFTER REPLACING OR REMOVING ENGINE PARTSDESCRIPTIONSPECIAL REPAIR REQUIREMENT
2015 Nissan-Datsun Juke SL, 4WD
Special Repair Requirement
2015 Nissan-Datsun Juke SL, 4WDSECTION Special Repair Requirement
*: Applicable
| Part Name | Service Performed | Required Service | Reference | |
|---|---|---|---|---|
| Replacement | Removal* | |||
| ECM | * | Additional service when replacing ECM | WORK PROCEDURE | |
| * | Accelerator pedal released position learning | WORK PROCEDURE | ||
| Throttle valve closed position learning | WORK PROCEDURE | |||
| Accelerator Pedal | * | * | Accelerator pedal released position learning | WORK PROCEDURE |
| G sensor | * | * | G sensor calibration | DESCRIPTION |
| Turbocharger assembly | * | * | Wastegate valve closed position learning | DESCRIPTION |
| Idle air volume learning | WORK PROCEDURE | |||
| Electric throttle | * | * | Throttle valve closed position learning | WORK PROCEDURE |
| Idle air volume learning | WORK PROCEDURE | |||
| * | Air fuel ratio initial learning | WORK PROCEDURE | ||
| Mass air flow sensor | * | Air fuel ratio initial learning | WORK PROCEDURE | |
| Fuel injector | * | |||
| Battery | * | Cumulative battery discharge current clear | WORK PROCEDURE | |
| Camshaft | * | Valve timing offset data clear | WORK PROCEDURE | |
| Valve timing offset data writing | DESCRIPTION | |||
| Timing chain | * | Valve timing offset data clear | WORK PROCEDURE | |
| Valve timing offset data writing | DESCRIPTION | |||
| Engine assembly | * | Idle air volume learning | WORK PROCEDURE | |
| Air fuel ratio initial learning | WORK PROCEDURE | |||
| Valve timing offset data clear | WORK PROCEDURE | |||
| Valve timing offset data writing | WORK PROCEDURE | |||
| Wastegate valve closed position learning | DESCRIPTION | |||
| Throttle valve closed position learning | WORK PROCEDURE | |||
* : Harness connector disconnection included.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.