Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Work Procedure
2015 Nissan-Datsun Juke SL, 4WDSECTION Work Procedure
CAUTION:
After replacing the following parts, remove 2D code label affixed to throttle valve.
- Camshaft
- Timing chain
- Engine assembly
- ERASE VALVE TIMING OFFSET DATA
With CONSULT
- Turn ignition switch ON.
- Select "VALVE TIMING OFFSET DATA CLEAR" in "WORK SUPPORT" mode of "ENGINE" using CONSULT.
- Touch "START" and erase valve timing offset data.
INSPECTION END
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.