Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER S PACEMAN, AUTOMATIC TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 870 (ENGINE - REPAIR)
2013 Mini Cooper S Paceman, Automatic Trans
Section 870 (Engine - Repair)
2013 Mini Cooper S Paceman, Automatic TransSECTION Section 870 (Engine - Repair)
WARNING: This page is about a different car, the 2005 BMW Z4, 2004 BMW Z4, and 2003 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
- Engine, General
- Cylinder Head With Cover
- 11 12 000 Removing and installing, sealing cylinder head cover (M52TU / M54 / M56)
- 11 12 100 Removing and installing/replacing cylinder head (M52TU / M54 / M56)
- 11 12 101 Replacing cylinder head gasket (M52 / S52 / M52TU / M54 / M56)
- 11 12 503 Disassembling and assembling cylinder head (M52 / S52 / M52TU / M54 / M56)
- 11 12 527 Remachining a valve seat (M52 / S52 / M52TU / M54 / M56)
- 11 12 595 Checking a valve guide for wear (M52 / S52 / M52TU / M54 / M56)
- 11 12 600 Reaming a valve guide (M52 / S52 / M52TU / M54 / M56)
- 11 12 719 Resurfacing cylinder head sealing surface (M52 / M52TU / M54 / M56)
- 11 12 729 Checking cylinder head for watertightness (M52TU / M54 / M56)
- Oil Sump
- Housing Cover
- Crankshaft With Bearing
- Flywheel
- Vibration Damper
- Connecting Rod With Bearing
- Piston With Rings and Pin
- V-ribbed Belt with Tensioner Deflect Element
- Camshaft
- Valves With Springs
- Variable Camshaft Timing
- Oil Supply
- Oil Pump With Filter and Drive
- Oil Filter and Lines
- Water Pump With Drive
- Thermostat and Connections
- Intake Manifold
- Exhaust Manifold
- Air Pump
- Emission Control, Oxygen Sensor
- Positive Crankcase Ventilation/Oil Separator
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.