Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 676 (DRIVE SHAFT)
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Section 676 (Drive Shaft)
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Section 676 (Drive Shaft)
WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Drive Shaft Location Index
- Rear Drive Shaft Inspection
- Rear Drive Shaft Removal/Installation
- Rear Drive Shaft Disassembly/Assembly
- Notes
- Boot Band (axle side) Disassembly Note
- Boot Band (Differential Side) Disassembly Note
- Outer Ring Disassembly Note
- Snap Ring, Tripod Joint Disassembly Note
- Boot Disassembly Note
- Boot Assembly Note
- Tripod Joint, Snap Ring Assembly Note
- Outer Ring Assembly Note
- Boot Band (Differential Side) Assembly Note
- Boot Band (Axle Side) Assembly Note
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.