Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Land Rover Range RoverFACTORY OEM SERVICE PROCEDURE
Engine Controls - Self-Diagnostics - Without Codes
- Introduction
- Mode $06 Data
- OBD Drive Cycle Information
- On Board Monitoring
- Notes
- Catalyst Monitoring
- Misfire Monitoring
- Secondary Air Injection System Monitoring
- Evaporative Emission System Leak Measurement
- Notes
- Leak Measurement Description
- EVAP System Leak Measurement Monitoring Structure
- EVAP System Diagnosis Frequency & MIL illumination
- Description Of EVAP Canister Purge System Flow Check
- EVAP Canister Purge System Monitoring Structure
- Monitoring Cycle Of Evaporative Emission Canister Purge System Flow Check
- Fuel Evaporative Emission System Monitoring
- EVAP System Drive Cycle Information
- Fuel System Monitoring
- Oxygen Sensor Monitoring
- Thermostat Monitoring
- Positive Crankcase Ventilation (PCV) System Monitoring
- Crankshaft Speed & Position Sensor
- Camshaft Position Control Interface (VANOS)
- Engine Coolant Temperature Sensor
- Mass Airflow Sensor & Intake Air Temperature Sensor
- Intake Air Temperature Sensor
- Knock Sensor
- Fuel Tank Level Sensor
- Throttle Position Sensor
- Engine Control Module Self Test
- Ambient Air Temperature Interface
- Vehicle Speed Interface
- Transfer Box Control Module Interface
- Can System
- Fuel Injectors
- Idle Speed Control Actuator
- Electronic Throttle Interface
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.