2003 Land Rover Range RoverFACTORY OEM SERVICE PROCEDURE

Engine Controls - Self-Diagnostics - Without Codes: Introduction: Notes

NOTE: For specific Diagnostic Trouble Code (DTC) testing, see DIAGNOSTIC TESTS article.

The Range Rover Petrol Engine Management System consists of the Bosch ME7.2 Engine Control Module (ECM) controlling the BMW 4.4L V8 M62 engine.

ME7.2 is a development of the Bosch M5.2.1 Engine Management System used on the Land Rover "Thor" V8 engine, the major difference being that ME7.2 is a "drive-by-wire" Engine Management system, i.e. ME7.2 has electronic throttle control.

Another significant system difference is the extensive use of a Controller Area Network (CAN) system to provide the interface to other vehicle systems.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.