Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Land Rover Range Rover BaseFACTORY OEM SERVICE PROCEDURE
Section 40 (Body Control Unit)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Land Rover Discovery, 2003 Land Rover Discovery, 2002 Land Rover Discovery, 2001 Land Rover Discovery, and 2000 Land Rover Discovery. However, it is still accessible from the selected car via links, so may be relevant.
- Description
- General
- IDM
- Transit mode
- Power supply
- Inputs and outputs
- Diagnostic socket
- Programmable options
- Anti-theft system
- Central Door Locking (CDL)
- Electric windows and sunroof
- Wipers and washers
- Electric seats
- Direction indicators and hazard warning lamps
- Headlamps
- Front fog lamps
- Instrument pack
- Starting
- Cruise control
- Shift interlock (where fitted)
- Ignition key interlock (where fitted)
- Transfer box interlock (where fitted)
- Gear position switch
- Transmission neutral selector
- Self levelling suspension and ABS
- Hill descent control
- Heated screens
- Interior courtesy lamps
- Fuel flap actuator
- Audible warnings
- Operation
- Notes
- Transit mode
- Anti-theft system
- Central door locking
- Electric windows and sunroof
- Heated screens
- Wipers and washers
- Electric seats
- Direction indicators and hazard warning lamps
- Courtesy headlamps
- Daylight running lamps
- Fog lamps
- Interior courtesy lamps
- Instrument pack
- Gear position indicator illumination
- Starter relay
- Cruise control
- Shift interlock (where fitted)
- Ignition interlock (where fitted)
- Transfer box interlock (where fitted)
- Gear position switch
- Fuel flap release
- Audible warnings
- SLABS raise/lower
- 86.55.75 Removal and Installation - Body control unit (BCU)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
