2000 Land Rover Range Rover BaseFACTORY OEM SERVICE PROCEDURE

Section 40 (Body Control Unit): Description: General

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Land Rover Discovery, 2003 Land Rover Discovery, 2002 Land Rover Discovery, 2001 Land Rover Discovery, and 2000 Land Rover Discovery. However, it is still accessible from the selected car via links, so may be relevant.

The Body Control Unit (BCU) is located behind the passenger glovebox and is connected to the main harness by four connectors on its bottom edge and an additional connector located on the side of the BCU casing. Mounting the BCU behind the fascia makes it reasonably inaccessible for intruders to disable the anti-theft system.

The BCU uses solid-state microprocessor control to perform logical operations and timing functions for a variety of the vehicle's electrically operated systems, these include:

  • Door locking.
  • Anti-theft alarm and immobilization system.
  • Exterior lighting including direction indicators and hazard warning lamps.
  • Courtesy lighting.
  • Wipers and washers.
  • Electric windows and sunroof.
  • Heated windows.

The BCU also communicates with several other electronically controlled systems such as the EAT ECU and SLABS ECU and also has a datalink between the Intelligent Driver Module (IDM) and the instrument pack. The datalink is a low speed bus capable of transmitting and receiving messages at a data rate of 10,400 bits per second. Additional inputs and outputs to peripheral devices are included which are necessary for determining vehicle status for particular logical operations e.g. crank, ignition key inserted, fuel flap enable etc.

The BCU receives its power supply from the engine compartment fuse box, and is protected by a 10 A fuse.

The BCU communicates with the IDM to provide the control signals to perform power switching operations in conjunction with dedicated relays.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.