2000 Land Rover Range Rover BaseFACTORY OEM SERVICE PROCEDURE

Diagnostic socket

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Land Rover Discovery, 2003 Land Rover Discovery, 2002 Land Rover Discovery, 2001 Land Rover Discovery, and 2000 Land Rover Discovery. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Diagnostic Socket
G03351701Courtesy of LAND ROVER NORTH AMERICA, INC.

RHD illustrated

The BCU has a serial connection to the diagnostic socket to allow unit interrogation using TestBook.

In addition to fault diagnosis, the BCU can be programmed with the following information:

  • Plip codes.
  • Options.
  • VIN code.
  • EKA code.
  • EEPROM locking.

The following manufacturing details are programmed into the BCU which can be accessed using TestBook:

  • Date of manufacture.
  • Hardware version number.
  • Unit serial number.
  • Odometer reading.

It is not possible to use the diagnostic bus to communicate with the BCU via TestBook when the security system is active (except for passive immobilization). This is a security measure to ensure that no key programming or market configuration can take place if the operator is not in possession of a valid remote transmitter or the vehicle keys.

The BCU is normally programmed to accept two remote transmitters, but a further two remote handsets can be programmed into the BCU and one optional Self Levelling Suspension (SLS) transmitter. All remote transmitters need to be available if TestBook is to be used to re-configure the BCU.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.