2000 Land Rover Range Rover BaseFACTORY OEM SERVICE PROCEDURE

Section 40 (Body Control Unit): Description: IDM

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Land Rover Discovery, 2003 Land Rover Discovery, 2002 Land Rover Discovery, 2001 Land Rover Discovery, and 2000 Land Rover Discovery. However, it is still accessible from the selected car via links, so may be relevant.

The IDM is integrated into the passenger compartment fuse box, which is mounted behind the fascia below the steering column. There are no harnesses between the fuse box and the IDM. The IDM performs the power switching operations for several of the vehicle's electrical systems.

The IDM communicates with the BCU and the instrument pack via a serial interface. If the BCU or the IDM is replaced, the communications link between the two units has to be re-established. This can be done either by switching on the ignition and leaving it on for five minutes, or by using TestBook. The vehicle immobilization will remain active until the communications link between the BCU and IDM has been re-established.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.