Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010RONDO LX, 2.7 6REPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM/ELECTRONIC STABILITY CONTROL (ABS/ESC) DIAGNOSIS
2010 Kia Rondo LX, 2.7 6
Anti-Lock Brake System/Electronic Stability Control (Abs/ESC) Diagnosis
2010 Kia Rondo LX, 2.7 6SECTION Anti-Lock Brake System/Electronic Stability Control (Abs/ESC) Diagnosis
- DTC Index
- DTC C1101: Battery voltage high
- DTC C1102: Battery voltage low
- DTC C1112: Sensor power voltage
- DTC C1200: Wheel speed sensor front-LH open-short
- DTC C1201: Wheel speed sensor front-LH range - performance - intermittent
- DTC C1202: Wheel speed sensor front-LH invalid-no signal
- DTC C1203: Wheel speed sensor front-RH open-short
- DTC C1204: Wheel speed sensor front-RH range-- performance --intermittent
- DTC C1205: Wheel speed sensor front-RH invalid-no signal
- DTC C1206: Wheel speed sensor rear-LH open-short
- DTC C1207: Wheel speed sensor rear-LH range-performance-intermittent
- DTC C1208: Wheel speed sensor rear-LH invalid-no signal
- DTC C1209: Wheel speed sensor rear-RH open-short
- DTC C1210: Wheel speed sensor rear-RH range-- performance-- intermittent
- DTC C1211: Wheel speed sensor rear-RH invalid-no signal
- DTC C1235: Primary pressure sensor - electrical
- DTC C1237: Primary pressure sensor - signal
- DTC C1259: Steering sensor - electrical
- DTC C1260: Steering sensor circuit - signal
- DTC C1282: Yaw rate and lateral G sensor - electrical
- DTC C1283: Yaw rate and lateral G sensor - signal
- DTC C1503: ESP switch error
- DTC C1513: Brake switch error
- DTC C1604: ECU Hardware Error
- DTC C1605: CAN Hardware Error
- DTC C1611: CAN time-out EMS
- DTC C1612: CAN time-out TCU
- DTC C1613: CAN wrong message
- DTC C1616: CAN bus off
- DTC C2112: Valve relay error
- DTC C2227: Excessive temperature of brake disc
- DTC C2380: ABS-ESC valve error
- DTC C2402: Motor electrical
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.