SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010RONDO LX, 2.7 6REPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM/ELECTRONIC STABILITY CONTROL (ABS/ESC) DIAGNOSISDTC C2227: EXCESSIVE TEMPERATURE OF BRAKE DISCGENERAL INFORMATIONDTC DETECTING CONDITION
2010 Kia Rondo LX, 2.7 6

General Information: DTC Detecting Condition

2010 Kia Rondo LX, 2.7 6SECTION DTC Detecting Condition
DTC C2227 DETECTING CONDITION CHART

Item Detecting Condition -
DTC Strategy
  • Internal monitoring
  • Faulty HECU
Detect Mode
  • Initial Check
  • Outside the ABS control cycle
  • Inside the ABS control cycle
 -
Enable Conditions
  • When the calculated temperature of disc is higher than predefined value (500°C).

    If the calculated temperature drops below 300°C, the controller recovers to normal state.

    • When IGN switched OFF, HECU calculate temperature of disc until calculated temperature drops below 80°C by BATT1 power.
Fail Safe
  • The ABS/EBD functions are not switched off. The ESC functions are switched off immediately.
  • The ESC warning lamps are activated.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.