Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE
Engine Control System - DTCS P0451 To P1212
- P0451 EVAP Control System Pressure Sensor
- P0452 EVAP Control System Pressure Sensor
- P0453 EVAP Control System Pressure Sensor
- P0455 EVAP Control System
- P0456 EVAP Control System
- P0460 Fuel Level Sensor
- P0461 Fuel Level Sensor
- P0462, P0463 Fuel Level Sensor
- P0500 VSS
- P0506 ISC System
- P0507 ISC System
- P0550 PSP Sensor
- P0603 ECM Power Supply
- P0605 ECM
- P0607 ECM
- P0643 Sensor Power Supply
- P0850 PNP Switch
- P1078, P1084 EVT Control Position Sensor
- P1148, P1168 Closed Loop Control
- P1211 TCS Control Unit
- P1212 TCS Communication Line
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.