2008 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE

Component Inspection

  1. EXHAUST VALVE TIMING CONTROL POSITION SENSOR-I
    1. Turn ignition switch OFF.
    2. Disconnect exhaust valve timing control position sensor harness connector.
    3. Loosen the fixing bolt of the sensor.
    4. Remove the sensor.
    5. Visually check the sensor for chipping.
    Fig 1: Identifying Valve Timing Control Position Sensor-I
    G04886870Courtesy of NISSAN MOTOR CO., U.S.A.

    Is the inspection result normal? 

    YES: GO TO 2.

    NO: Replace malfunctioning exhaust valve timing control position sensor.

  2. EXHAUST VALVE TIMING CONTROL POSITION SENSOR-II

    Check resistance exhaust valve timing control position sensor terminals as shown below.

    RESISTANCE SPECIFICATIONS

    Terminals Resistance
    1 (+) - 2 (-) Except 0 or ∞ Ω [at 25°C (77°F)]
    1 (+) - 3 (-)
    2 (+) - 3 (-)

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Replace malfunctioning exhaust valve timing control position sensor.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.