2008 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE

DTC Detection Logic

NOTE:
  • If DTC P1212 is displayed with DTC U1000 or U1001, first perform the trouble diagnosis for DTC U1000, U1001. Refer to "DTC LOGIC ".
  • If DTC P1212 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to "DTC LOGICΒ ".

Freeze frame data is not stored in the ECM for this self-diagnosis.Β 

DTC DETECTING CONDITION AND POSSIBLE CAUSE REFERENCE

DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P1212 TCS communication line ECM can not receive the information from "ABS actuator and electric unit (control unit)" continuously.
  • Harness or connectors (The CAN communication line is open or shorted.)
  • ABS actuator and electric unit (control unit)
  • Dead (Weak) battery
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.