Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Infiniti EX35 Base, RWDFACTORY OEM SERVICE PROCEDURE
Component Inspection
- CHECK POWER STEERING PRESSURE SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Start engine and let it idle.
- Check the voltage between ECM harness connector terminals under the following conditions.VOLTAGE SPECIFICATIONS
ECM Condition Voltage (V) Connector + - Terminal Terminal F102 87 96 Steering wheel Being turned 0.5 - 4.5 Not being turned 0.4 - 0.8
Is the inspection result normal?
YES: INSPECTION END
NO: Replace power steering pressure sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.