Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2003FX45REPAIR AND DIAGNOSISSTEERINGSTEERING COLUMNAUTOMATIC DRIVE POSITIONER
2003 Infiniti FX45
Automatic Drive Positioner
2003 Infiniti FX45SECTION Automatic Drive Positioner
- Manual Operation
- Automatic Operation
- System Description
- Component Parts And Harness Connector Location
- CAN Communication System Description
- Schematic
- Wiring Diagram-AUT/DP-
- Terminals and Reference Values for BCM
- Terminals and Reference Values for Automatic Drive Positioner Control Unit
- Terminals and Reference Values for Driver Seat Control Unit
- Work Flow
- Preliminary Check
- CONSULT-II Function
- Can Communication Inspection Using Consult-II (Self-Diagnosis)
- Symptom Chart
- Sliding Motor Circuit Inspection
- Reclining Motor Circuit Inspection
- Front Lifting Motor Circuit Inspection
- Rear Lifting Motor Circuit Inspection
- Telescopic Motor Circuit Inspection
- Tilt Motor Circuit Inspection
- Mirror Motor (Driver Side) Circuit Check
- Mirror Motor (Passenger Side) Circuit Check
- Sliding Sensor Circuit Inspection
- Reclining Sensor Circuit Inspection
- Front Lifting Sensor Circuit Inspection
- Rear Lifting Sensor Circuit Inspection
- Telescopic Sensor Circuit Inspection
- Tilt Sensor Circuit Inspection
- Mirror Sensor (Driver Side) Circuit Check
- Mirror Sensor (Passenger Side) Circuit Check
- Steering and Door Mirror Sensor Power and Ground Circuit Inspection
- Front Door Switch (Driver Side) Circuit Inspection
- Sliding Switch Circuit Inspection
- Reclining Switch Inspection
- Front Lifting Switch Circuit Inspection
- Rear Lifting Switch Circuit Inspection
- Sliding Switch and Reclining Switch Ground Circuit Inspection
- Front Lifting Switch and Rear Lifting Switch Ground Circuit Inspection
- Telescopic Switch Circuit Inspection
- Tilt Switch Circuit Inspection
- Door Mirror Remote Control Switch (Changeover switch) Circuit Check
- Door Mirror Remote Control Switch (Mirror Switch) Circuit Check
- Detention Switch (P Range Switch) Circuit Inspection
- Key Switch and Ignition Knob Switch Circuit Inspection (With Intelligent Key)
- Key Switch Circuit Inspection (Without Intelligent Key)
- Seat Memory Switch Circuit Inspection
- Memory Indicator Lamp Circuit Inspection
- UART Communication Line Circuit Inspection
- Lumber Support Circuit Inspection
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.