Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Ford Transit Connect XLFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System And Stability Control
- Specifications
- Description And Operation
- Diagnosis And Testing
- Anti-Lock Control
- Notes
- Principles of Operation
- Anti-Lock Control
- Electronic Brake Distribution (EBD)
- AdvanceTrac® Stability Enhancement System
- Traction Control System
- Electronic Stability Control (ESC) System
- Roll Stability Control (RSC®)
- Stability Control Sensors
- Steering Angle Sensor Module (SASM)
- Traction Control Switch
- Stability/Traction Control Indicator "Sliding-Car Icon"
- ABS Module Calibration
- ABS Module Configuration
- Inspection and Verification
- DTC Charts
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: DTCs C0020:01, 1C and 71
- Pinpoint Test B: DTC C0031:11, 15; C0034:11, 15; C0037:11, 15; or C003A:11, 15
- Pinpoint Test C: DTC C0030:07; C0031:07; C0033:07; C0034:07; C0036:07; C0037:07; C0039:07; and C003A:07
- Pinpoint Test D: DTC C0040:64
- Pinpoint Test E: DTCs C0051:28 and 54
- Pinpoint Test F: DTCs C0061:28, 54; C0062:28, 54; C0063:28 and C0064:28
- Pinpoint Test G: DTCs C006A:01, 16, 17, 95; U0125:00 and U0125:88
- Pinpoint Test H: DTCs U0428:00, 41, 61, 62 and 64
- Pinpoint Test I: DTCs U3003:16, 17 and 62
- Pinpoint Test J: DTC U2101:00
- Pinpoint Test K: DTCs C0061:64; C0062:64; C0063:64 and C0064:64
- Anti-Lock Control
- Removal And Installation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.